Request Information
A formulated polyurethane topcoat which gives a soft, silky feel at low gloss levels (2-4 gloss at 60 degree geometry).

Suggested Uses: L-3033 is designed primarily for use on synthetic leather-like surfaces such as PVC, urethane, and various TPO's, as well as plastic films and other smooth surfaces.

Characteristics:
  • Soft, silky feel
  • Inherently low gloss without the use of silica
  • Can be crosslinked to enhance performance
  • Dilution and clean-up with water
  • Low VOC: <100 g/L
Unit of Measure

Physical Properties

Solids

 N/A 29 %

Solids Tolerance

 N/A ± 2 %

Viscosity

 N/A 100 to 300 cps / 26-30 sec #5 Shell cup

pH

 N/A 8.0 to 9.5

Density

 N/A 8.5 lb/gal

Volatile Organic Compounds (VOC) Content (Less Water)

 N/A 72 g/L

Application

N/A L-3033 does not have defoamer or wetting agent, allowing the formulator flexibility of selection for his specific application. May be applied by rotogravure, wire wound rod and spray.

Curing

N/A L-3033 can be air-dried. Typical drying temperatures and dwell times for aqueous coatings are sufficient to produce optimal film properties. L-3033 may be crosslinked with carbodiimides, water-dispersible isocyanates or polyaziridines to further enhance performance.